CAME VER KIT Bedienungsanleitung PDF herunterladen (Seite 31)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

Photo 4.13

Gently bring the drill bit into contact with the plate, then

tighten the stopper to mark the position shown in figure

4.1 (a) (photos 4.13 and 4.14).

(Note: If the drill bit is brought into contact with the

work piece too forcefully, the position will not

be the true 0 mm position.)

Raise the drill, then move the slider on the gauge

indicated by the arrow in photo 4.15 up by 2 mm.

Photo 4.14

Tighten the stopper.

Photo 4.15

Move up by 2 gradations.

Photo 4.16

If the drill bit goes all the way through the work piece,

you moved the slider more than 2 mm. Adjust the slider

position a little bit at a time.

When a flathead screw fits neatly into the hole as

shown in photo 4.17, the task is complete.

Photo 4.17

Test preparing a hole for a flathead screw. The

stopper is now adjusted, so lower the drill all the

way. The bit should stop before it passes all the way

through the work piece. Photo 4.16 shows what the

work piece looks like after preparing a hole for a

flathead screw.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 91 92

Keine Kommentare

CAME VER KIT Bedienungsanleitung Seite 31