CAME VER KIT Bedienungsanleitung PDF herunterladen (Seite 30)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

4.2. Preparing Holes for Flathead Screws

Plate Plate

Drill

dia.6 mm

Drill

dia.6 mm

Flathead screw

(a) (b)

Depth 0 mm Depth 2 mm

The holes are prepared for flathead screws so that the screw head will not stick out above the surface of the board,

as shown in figure 4.1. It requires that the drill cut only partway into the plate. Here we describe a method that

uses the stopper of a tabletop drill press to accomplish this.

4.2.1. Height Adjustment of Drill Bit

As when drilling the holes for the toggle switches, we will use a dia. 6 mm drill bit for this task, so there is no

need to change the drill bit.

(Note: This description assumes that a drill bit (dia. 6 mm) is already mounted in the drill.)

Figure 4.1

Photo 4.11

Loosen the stopper as shown in photo 4.11.

Loosen the stopper.

Photo 4.12

Use a leftover piece of the plate to adjust the drill height.

The head portion of each flathead screw (arrow) is

2 mm deep (photo 4.10).

If the point at which the drill bit meets the work piece is

0 mm (figure 4.1 (a)), we need to lower the drill a

distance of 2 mm (4.1 (b)).

Photo 4.10

2 mm

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 91 92

Keine Kommentare

CAME VER KIT Bedienungsanleitung Seite 30